naming_conventions

Get Example source ABAP code based on a different SAP table
  


ARTICLE

Naming Conventions and Namespaces

Naming Conventions
The following conventions apply for the names of all definable objects within ABAP programs, such as data types, data objects, classes, macros, or procedures:
A name can be up to 30 characters in length.
Permitted are letters from 'A' to 'Z', numbers from '0' to '9', and underscores (_). Outside of ABAP objects and non- Unicode programs, the name can start with other characters. If, however, characters are used that are not available in all code pages supported by SAP, it might not be possible to run certain programs when using a different code page to the one in which they were created.
The name must start with a letter or an underscore (_). Only outside of ABAP objects can the name also start with a different character.
The name can have a namespace prefix. A namespace prefix consists of at least three characters that are delimited by two backslashes (/.../ ). The entire length of prefix and name cannot exceed 30 characters.
For data types and data objects, the names of predefined ABAP types or predefined data objects cannot be used.
Using IDs that are reserved for ABAP words and so on for user-defined definitions is not actually forbidden, but it is strongly advised against.
Field symbols are special in that their names have to be enclosed in parentheses (<(><<)>>).

ABAP_PGL Program-Internal Names

Notes
All types possible in ABAP are in a namespace. Data types and object types do not have separate namespaces. A global class, for example, cannot be created with a name that is already being used for a data type in ABAP Dictionary.
The naming conventions presented here must be followed. They are not checked in full by the syntax check, but they must not be broken more than absolutely necessary. The program DEMO_CHARACTERS_IN_ABAP_NAMES demonstrates how these checks run in the current system.

Namespaces
Outside of class declarations, different objects have separate namespaces, so it is possible that data types, data objects or proced ures can have the same name. Classes and interfaces thus lie within the same namespace as data types. The namespace is valid for the respective context. Within a context, the names of the same objects must be unique. For example, there can only be one subprogram of a name in an ABAP program and only one function module of a name in the entire AS ABAP.
Within a class declaration, the name of every class component (data type, attribute, method, event, or alias name) must be unique.